U-Boot 1.1.4 (Nov 1 2012 - 10:25:30) U-boot AP123 DRAM: 32 MB id read 0x100000ff Flash: 4 MB Using default environment In: serial Out: serial Err: serial Net: ag934x_enet_initialize... wasp reset mask:c03300 WASP ----> S27 PHY file: ag934x.c,line: 179==: set LAN&WAN SWAP. --debug by HouXB GMAC: cfg1 0x5 cfg2 0x7114 eth0: ba:be:fa:ce:08:41 s27 reg init athrs27_phy_setup ATHR_PHY_CONTROL 4: 0x1000 athrs27_phy_setup ATHR_PHY_SPEC_STAUS 4: 0x10 eth0 up WASP ----> S27 PHY file: ag934x.c,line: 179==: set LAN&WAN SWAP. --debug by HouXB GMAC: cfg1 0xf cfg2 0x7214 eth1: ba:be:fa:ce:08:41 s27 reg init lan ATHRS27: resetting s27 ATHRS27: s27 reset done athrs27_phy_setup ATHR_PHY_CONTROL 0: 0x1000 athrs27_phy_setup ATHR_PHY_SPEC_STAUS 0: 0x10 athrs27_phy_setup ATHR_PHY_CONTROL 1: 0x1000 athrs27_phy_setup ATHR_PHY_SPEC_STAUS 1: 0x10 athrs27_phy_setup ATHR_PHY_CONTROL 2: 0x1000 athrs27_phy_setup ATHR_PHY_SPEC_STAUS 2: 0x10 athrs27_phy_setup ATHR_PHY_CONTROL 3: 0x1000 athrs27_phy_setup ATHR_PHY_SPEC_STAUS 3: 0x10 eth1 up eth0, eth1 Autobooting in 1 seconds ## Booting image at 9f020000 ... Uncompressing Kernel Image ... OK Starting kernel ... [ 0.000000] Linux version 3.10.10 (bastian@gcc20) (gcc version 4.6.4 (OpenWrt/Linaro GCC 4.6-2012.12 r37919) ) #1 Sun Sep 8 22:02:43 CEST 2013 [ 0.000000] bootconsole [early0] enabled [ 0.000000] CPU revision is: 0001974c (MIPS 74Kc) [ 0.000000] SoC: Atheros AR9341 rev 3 [ 0.000000] Clocks: CPU:535.000MHz, DDR:400.000MHz, AHB:200.000MHz, Ref:25.000MHz [ 0.000000] Determined physical RAM map: [ 0.000000] memory: 02000000 @ 00000000 (usable) [ 0.000000] bb Doing memory test... [ 0.000000] Initrd not found or empty - disabling initrd [ 0.000000] Zone ranges: [ 0.000000] Normal [mem 0x00000000-0x01ffffff] [ 0.000000] Movable zone start for each node [ 0.000000] Early memory node ranges [ 0.000000] node 0: [mem 0x00000000-0x01ffffff] [ 0.000000] Primary instruction cache 64kB, VIPT, 4-way, linesize 32 bytes. [ 0.000000] Primary data cache 32kB, 4-way, VIPT, cache aliases, linesize 32 bytes [ 0.000000] Built 1 zonelists in Zone order, mobility grouping on. Total pages: 8128 [ 0.000000] Kernel command line: board=TL-WR841N-v8 console=ttyS0,115200 rootfstype=squashfs,jffs2 noinitrd [ 0.000000] PID hash table entries: 128 (order: -3, 512 bytes) [ 0.000000] Dentry cache hash table entries: 4096 (order: 2, 16384 bytes) [ 0.000000] Inode-cache hash table entries: 2048 (order: 1, 8192 bytes) [ 0.000000] Writing ErrCtl register=00000000 [ 0.000000] Readback ErrCtl register=00000000 [ 0.000000] Memory: 29040k/32768k available (2181k kernel code, 3728k reserved, 417k data, 216k init, 0k highmem) [ 0.000000] SLUB: HWalign=32, Order=0-3, MinObjects=0, CPUs=1, Nodes=1 [ 0.000000] NR_IRQS:51 [ 0.000000] Calibrating delay loop... 266.64 BogoMIPS (lpj=1333248) [ 0.080000] pid_max: default: 32768 minimum: 301 [ 0.080000] Mount-cache hash table entries: 512 [ 0.090000] NET: Registered protocol family 16 [ 0.090000] MIPS: machine is TP-LINK TL-WR841N/ND v8 [ 0.500000] bio: create slab at 0 [ 0.510000] Switching to clocksource MIPS [ 0.520000] NET: Registered protocol family 2 [ 0.520000] TCP established hash table entries: 512 (order: 0, 4096 bytes) [ 0.520000] TCP bind hash table entries: 512 (order: -1, 2048 bytes) [ 0.530000] TCP: Hash tables configured (established 512 bind 512) [ 0.530000] TCP: reno registered [ 0.530000] UDP hash table entries: 256 (order: 0, 4096 bytes) [ 0.540000] UDP-Lite hash table entries: 256 (order: 0, 4096 bytes) [ 0.550000] NET: Registered protocol family 1 [ 0.570000] squashfs: version 4.0 (2009/01/31) Phillip Lougher [ 0.570000] jffs2: version 2.2 (NAND) (SUMMARY) (LZMA) (RTIME) (CMODE_PRIORITY) (c) 2001-2006 Red Hat, Inc. [ 0.580000] msgmni has been set to 56 [ 0.590000] io scheduler noop registered [ 0.590000] io scheduler deadline registered (default) [ 0.600000] Serial: 8250/16550 driver, 1 ports, IRQ sharing disabled [ 0.620000] serial8250.0: ttyS0 at MMIO 0x18020000 (irq = 11) is a 16550A [ 0.630000] console [ttyS0] enabled, bootconsole disabled [ 0.630000] console [ttyS0] enabled, bootconsole disabled [ 0.640000] ath79-spi ath79-spi: master is unqueued, this is deprecated [ 0.650000] m25p80 spi0.0: found en25q32b, expected m25p80 [ 0.660000] m25p80 spi0.0: en25q32b (4096 Kbytes) [ 0.660000] 5 tp-link partitions found on MTD device spi0.0 [ 0.670000] Creating 5 MTD partitions on "spi0.0": [ 0.670000] 0x000000000000-0x000000020000 : "u-boot" [ 0.680000] 0x000000020000-0x000000103e78 : "kernel" [ 0.690000] mtd: partition "kernel" must either start or end on erase block boundary or be smaller than an erase block -- forcing read-only [ 0.700000] 0x000000103e78-0x0000003f0000 : "rootfs" [ 0.710000] mtd: partition "rootfs" must either start or end on erase block boundary or be smaller than an erase block -- forcing read-only [ 0.720000] mtd: partition "rootfs" set to be root filesystem [ 0.730000] mtd: partition "rootfs_data" created automatically, ofs=0x330000, len=0xc0000 [ 0.740000] 0x000000330000-0x0000003f0000 : "rootfs_data" [ 0.740000] 0x0000003f0000-0x000000400000 : "art" [ 0.750000] 0x000000020000-0x0000003f0000 : "firmware" [ 0.770000] libphy: ag71xx_mdio: probed [ 0.780000] eth0: Atheros AG71xx at 0xb9000000, irq 4, mode:MII [ 1.330000] ag71xx ag71xx.0 eth0: connected to PHY at ag71xx-mdio.1:00 [uid=004dd042, driver=Generic PHY] [ 1.350000] eth1: Atheros AG71xx at 0xba000000, irq 5, mode:GMII [ 1.900000] eth1: Found an AR934X built-in switch [ 2.940000] TCP: cubic registered [ 2.940000] NET: Registered protocol family 17 [ 2.950000] 8021q: 802.1Q VLAN Support v1.8 [ 2.960000] VFS: Mounted root (squashfs filesystem) readonly on device 31:2. [ 2.970000] Freeing unused kernel memory: 216K (802ea000 - 80320000) procd: Console is alive procd: - watchdog - [ 4.780000] usbcore: registered new interface driver usbfs [ 4.790000] usbcore: registered new interface driver hub [ 4.800000] usbcore: registered new device driver usb [ 4.880000] ehci_hcd: USB 2.0 'Enhanced' Host Controller (EHCI) Driver [ 4.890000] ehci-platform: EHCI generic platform driver [ 4.900000] ohci_hcd: USB 1.1 'Open' Host Controller (OHCI) Driver procd: - preinit -