[ 0.000000] Linux version 3.3.8 (bastian@j16415.servers.jiffybox.net) (gcc version 4.6.3 20120201 (prerelease) (Linaro GCC 4.6-2012.02) ) #1 Sat Jul 28 00:50:47 CEST 2012 [ 0.000000] MyLoader: sysp=51aa55aa, boardp=00000000, parts=d5aa55aa [ 0.000000] bootconsole [early0] enabled [ 0.000000] CPU revision is: 00019374 (MIPS 24Kc) [ 0.000000] SoC: Atheros AR7241 rev 1 [ 0.000000] Clocks: CPU:390.000MHz, DDR:390.000MHz, AHB:195.000MHz, Ref:5.000MHz [ 0.000000] Determined physical RAM map: [ 0.000000] memory: 02000000 @ 00000000 (usable) [ 0.000000] Initrd not found or empty - disabling initrd [ 0.000000] Zone PFN ranges: [ 0.000000] Normal 0x00000000 -> 0x00002000 [ 0.000000] Movable zone start PFN for each node [ 0.000000] Early memory PFN ranges [ 0.000000] 0: 0x00000000 -> 0x00002000 [ 0.000000] On node 0 totalpages: 8192 [ 0.000000] free_area_init_node: node 0, pgdat 802f7730, node_mem_map 81000000 [ 0.000000] Normal zone: 64 pages used for memmap [ 0.000000] Normal zone: 0 pages reserved [ 0.000000] Normal zone: 8128 pages, LIFO batch:0 [ 0.000000] pcpu-alloc: s0 r0 d32768 u32768 alloc=1*32768 [ 0.000000] pcpu-alloc: [0] 0 [ 0.000000] Built 1 zonelists in Zone order, mobility grouping on. Total pages: 8128 [ 0.000000] Kernel command line: board=UBNT-NM console=ttyS0,115200 mtdparts=spi0.0:256k(u-boot)ro,64k(u-boot-env)ro,1024k(kernel),6528k(rootfs),256k(cfg)ro,64k(EEPROM)ro,7552k@0x50000(firmware) rootfstype=squashfs,jffs2 noinitrd [ 0.000000] PID hash table entries: 128 (order: -3, 512 bytes) [ 0.000000] Dentry cache hash table entries: 4096 (order: 2, 16384 bytes) [ 0.000000] Inode-cache hash table entries: 2048 (order: 1, 8192 bytes) [ 0.000000] Primary instruction cache 64kB, VIPT, 4-way, linesize 32 bytes. [ 0.000000] Primary data cache 32kB, 4-way, VIPT, cache aliases, linesize 32 bytes [ 0.000000] Writing ErrCtl register=00000000 [ 0.000000] Readback ErrCtl register=00000000 [ 0.000000] Memory: 29100k/32768k available (2102k kernel code, 3668k reserved, 553k data, 204k init, 0k highmem) [ 0.000000] SLUB: Genslabs=9, HWalign=32, Order=0-3, MinObjects=0, CPUs=1, Nodes=1 [ 0.000000] NR_IRQS:51 [ 0.000000] Calibrating delay loop... 259.27 BogoMIPS (lpj=1296384) [ 0.070000] pid_max: default: 32768 minimum: 301 [ 0.070000] Mount-cache hash table entries: 512 [ 0.080000] NET: Registered protocol family 16 [ 0.080000] gpiochip_add: registered GPIOs 0 to 17 on device: ath79 [ 0.090000] MIPS: machine is Ubiquiti Nanostation M [ 0.090000] registering PCI controller with io_map_base unset [ 0.500000] bio: create slab at 0 [ 0.510000] PCI host bridge to bus 0000:00 [ 0.510000] pci_bus 0000:00: root bus resource [mem 0x10000000-0x13ffffff] [ 0.520000] pci_bus 0000:00: root bus resource [io 0x0000] [ 0.520000] pci 0000:00:00.0: [168c:002a] type 0 class 0x000280 [ 0.520000] pci 0000:00:00.0: fixup device configuration [ 0.530000] pci 0000:00:00.0: reg 10: [mem 0x10000000-0x1000ffff 64bit] [ 0.530000] pci 0000:00:00.0: supports D1 [ 0.530000] pci 0000:00:00.0: PME# supported from D0 D1 D3hot [ 0.530000] pci 0000:00:00.0: BAR 0: assigned [mem 0x10000000-0x1000ffff 64bit] [ 0.530000] pci 0000:00:00.0: using irq 40 for pin 1 [ 0.540000] Switching to clocksource MIPS [ 0.540000] NET: Registered protocol family 2 [ 0.550000] IP route cache hash table entries: 1024 (order: 0, 4096 bytes) [ 0.550000] TCP established hash table entries: 1024 (order: 1, 8192 bytes) [ 0.560000] TCP bind hash table entries: 1024 (order: 0, 4096 bytes) [ 0.560000] TCP: Hash tables configured (established 1024 bind 1024) [ 0.570000] TCP reno registered [ 0.570000] UDP hash table entries: 256 (order: 0, 4096 bytes) [ 0.580000] UDP-Lite hash table entries: 256 (order: 0, 4096 bytes) [ 0.590000] NET: Registered protocol family 1 [ 0.590000] PCI: CLS 0 bytes, default 32 [ 0.610000] squashfs: version 4.0 (2009/01/31) Phillip Lougher [ 0.610000] JFFS2 version 2.2 (NAND) (SUMMARY) (LZMA) (RTIME) (CMODE_PRIORITY) (c) 2001-2006 Red Hat, Inc. [ 0.630000] msgmni has been set to 56 [ 0.630000] io scheduler noop registered [ 0.630000] io scheduler deadline registered (default) [ 0.640000] Serial: 8250/16550 driver, 1 ports, IRQ sharing disabled [ 0.670000] serial8250.0: ttyS0 at MMIO 0x18020000 (irq = 11) is a 16550A [ 0.670000] console [ttyS0] enabled, bootconsole disabled [ 0.690000] m25p80 spi0.0: found s25fl064k, expected m25p80 [ 0.690000] m25p80 spi0.0: s25fl064k (8192 Kbytes) [ 0.700000] 7 cmdlinepart partitions found on MTD device spi0.0 [ 0.700000] Creating 7 MTD partitions on "spi0.0": [ 0.710000] 0x000000000000-0x000000040000 : "u-boot" [ 0.720000] 0x000000040000-0x000000050000 : "u-boot-env" [ 0.720000] 0x000000050000-0x000000150000 : "kernel" [ 0.730000] 0x000000150000-0x0000007b0000 : "rootfs" [ 0.740000] mtd: partition "rootfs" set to be root filesystem [ 0.740000] mtd: partition "rootfs_data" created automatically, ofs=320000, len=490000 [ 0.750000] 0x000000320000-0x0000007b0000 : "rootfs_data" [ 0.760000] 0x0000007b0000-0x0000007f0000 : "cfg" [ 0.760000] 0x0000007f0000-0x000000800000 : "EEPROM" [ 0.770000] 0x000000050000-0x0000007b0000 : "firmware" [ 0.790000] ag71xx_mdio: probed [ 0.790000] eth0: Atheros AG71xx at 0xb9000000, irq 4 [ 1.350000] ag71xx ag71xx.0: eth0: connected to PHY at ag71xx-mdio.1:04 [uid=004dd041, driver=Generic PHY] [ 1.360000] eth1: Atheros AG71xx at 0xba000000, irq 5 [ 1.910000] eth1: Found an AR7240/AR9330 built-in switch [ 2.950000] zram: num_devices not specified. Using default: 1 [ 2.950000] zram: Creating 1 devices ... [ 2.960000] TCP cubic registered [ 2.960000] NET: Registered protocol family 17 [ 2.960000] 8021q: 802.1Q VLAN Support v1.8 [ 2.970000] VFS: Mounted root (squashfs filesystem) readonly on device 31:3. [ 2.980000] Freeing unused kernel memory: 204k freed [ 5.090000] Registered led device: ubnt:red:link1 [ 5.090000] Registered led device: ubnt:orange:link2 [ 5.090000] Registered led device: ubnt:green:link3 [ 5.090000] Registered led device: ubnt:green:link4 [ 7.360000] eth0: link up (100Mbps/Full duplex) [ 8.420000] eth0: link down [ 15.510000] Compat-wireless backport release: compat-wireless-2012-07-13 [ 15.520000] Backport based on wireless-testing.git master-2012-07-16 [ 15.520000] compat.git: wireless-testing.git [ 15.560000] cfg80211: Calling CRDA to update world regulatory domain [ 15.570000] cfg80211: World regulatory domain updated: [ 15.570000] cfg80211: (start_freq - end_freq @ bandwidth), (max_antenna_gain, max_eirp) [ 15.580000] cfg80211: (2400000 KHz - 2494000 KHz @ 40000 KHz), (N/A, 3500 mBm) [ 15.590000] cfg80211: (4910000 KHz - 5895000 KHz @ 40000 KHz), (N/A, 3500 mBm) [ 15.940000] usbcore: registered new interface driver usbfs [ 15.940000] usbcore: registered new interface driver hub [ 15.950000] usbcore: registered new device driver usb [ 16.440000] PCI: Enabling device 0000:00:00.0 (0000 -> 0002) [ 16.460000] ath: EEPROM regdomain: 0x0 [ 16.460000] ath: EEPROM indicates default country code should be used [ 16.460000] ath: doing EEPROM country->regdmn map search [ 16.460000] ath: country maps to regdmn code: 0x3a [ 16.460000] ath: Country alpha2 being used: US [ 16.460000] ath: Regpair used: 0x3a [ 16.460000] ieee80211 phy0: Selected rate control algorithm 'minstrel_ht' [ 16.460000] Registered led device: ath9k-phy0 [ 16.460000] ieee80211 phy0: Atheros AR9280 Rev:2 mem=0xb0000000, irq=40 [ 16.470000] cfg80211: Calling CRDA for country: US [ 16.480000] cfg80211: Regulatory domain changed to country: US [ 16.480000] cfg80211: (start_freq - end_freq @ bandwidth), (max_antenna_gain, max_eirp) [ 16.490000] cfg80211: (2400000 KHz - 2494000 KHz @ 40000 KHz), (N/A, 3500 mBm) [ 16.500000] cfg80211: (4910000 KHz - 5895000 KHz @ 40000 KHz), (N/A, 3500 mBm) [ 16.550000] PPP generic driver version 2.4.2 [ 16.710000] ip_tables: (C) 2000-2006 Netfilter Core Team [ 16.840000] NET: Registered protocol family 24 [ 16.860000] ehci_hcd: USB 2.0 'Enhanced' Host Controller (EHCI) Driver [ 16.890000] nf_conntrack version 0.5.0 (457 buckets, 1828 max) [ 17.140000] xt_time: kernel timezone is -0000 [ 17.310000] ohci_hcd: USB 1.1 'Open' Host Controller (OHCI) Driver [ 21.250000] device eth0 entered promiscuous mode [ 23.520000] eth0: link up (100Mbps/Full duplex) [ 23.520000] br-lan: port 1(eth0) entered forwarding state [ 23.530000] br-lan: port 1(eth0) entered forwarding state [ 25.530000] br-lan: port 1(eth0) entered forwarding state [ 39.890000] Adding 4092k swap on /dev/zram0. Priority:-1 extents:1 across:4092k SS [ 40.650000] jffs2_scan_eraseblock(): End of filesystem marker found at 0x0 [ 40.670000] jffs2_build_filesystem(): unlocking the mtd device... done. [ 40.670000] jffs2_build_filesystem(): erasing all blocks after the end marker... done. [ 53.110000] JFFS2 notice: (2075) jffs2_build_xattr_subsystem: complete building xattr subsystem, 0 of xdatum (0 unchecked, 0 orphan) and 0 of xref (0 dead, 0 orphan) found.