[ 0.000000] Linux version 3.3.8 (bastian@gcc20) (gcc version 4.6.4 20121210 (prerelease) (Linaro GCC 4.6-2012.12) ) #3 Thu Jan 17 12:27:39 CET 2013 [ 0.000000] gpiochip_add: registered GPIOs 0 to 21 on device: ar5312-gpio [ 0.000000] ar5312-gpio: registered 22 GPIOs [ 0.000000] bootconsole [early0] enabled [ 0.000000] CPU revision is: 0001800a (MIPS 4Kc) [ 0.000000] Determined physical RAM map: [ 0.000000] memory: 01000000 @ 00000000 (usable) [ 0.000000] Initrd not found or empty - disabling initrd [ 0.000000] Zone PFN ranges: [ 0.000000] Normal 0x00000000 -> 0x00001000 [ 0.000000] Movable zone start PFN for each node [ 0.000000] Early memory PFN ranges [ 0.000000] 0: 0x00000000 -> 0x00001000 [ 0.000000] On node 0 totalpages: 4096 [ 0.000000] free_area_init_node: node 0, pgdat 802df890, node_mem_map 80339000 [ 0.000000] Normal zone: 32 pages used for memmap [ 0.000000] Normal zone: 0 pages reserved [ 0.000000] Normal zone: 4064 pages, LIFO batch:0 [ 0.000000] pcpu-alloc: s0 r0 d32768 u32768 alloc=1*32768 [ 0.000000] pcpu-alloc: [0] 0 [ 0.000000] Built 1 zonelists in Zone order, mobility grouping off. Total pages: 4064 [ 0.000000] Kernel command line: console=ttyS0,9600 rootfstype=squashfs,jffs2 oops=panic panic=10 [ 0.000000] PID hash table entries: 64 (order: -4, 256 bytes) [ 0.000000] Dentry cache hash table entries: 2048 (order: 1, 8192 bytes) [ 0.000000] Inode-cache hash table entries: 1024 (order: 0, 4096 bytes) [ 0.000000] Primary instruction cache 16kB, VIPT, 4-way, linesize 16 bytes. [ 0.000000] Primary data cache 16kB, 4-way, VIPT, no aliases, linesize 16 bytes [ 0.000000] Memory: 12884k/16384k available (2191k kernel code, 3500k reserved, 492k data, 164k init, 0k highmem) [ 0.000000] NR_IRQS:128 [ 0.000000] console [ttyS0] enabled, bootconsole disabled [ 0.010000] Calibrating delay loop... 179.60 BogoMIPS (lpj=898048) [ 0.110000] pid_max: default: 32768 minimum: 301 [ 0.120000] Mount-cache hash table entries: 512 [ 0.140000] NET: Registered protocol family 16 [ 0.210000] bio: create slab at 0 [ 0.230000] Switching to clocksource MIPS [ 0.260000] NET: Registered protocol family 2 [ 0.310000] IP route cache hash table entries: 1024 (order: 0, 4096 bytes) [ 0.400000] TCP established hash table entries: 512 (order: 0, 4096 bytes) [ 0.480000] TCP bind hash table entries: 512 (order: -1, 2048 bytes) [ 0.560000] TCP: Hash tables configured (established 512 bind 512) [ 0.630000] TCP reno registered [ 0.670000] UDP hash table entries: 256 (order: 0, 4096 bytes) [ 0.740000] UDP-Lite hash table entries: 256 (order: 0, 4096 bytes) [ 0.820000] NET: Registered protocol family 1 [ 0.870000] PCI: CLS 0 bytes, default 16 [ 0.870000] Radio config found at offset 0x2000(0x100) [ 0.960000] squashfs: version 4.0 (2009/01/31) Phillip Lougher [ 1.030000] JFFS2 version 2.2 (NAND) (SUMMARY) (LZMA) (RTIME) (CMODE_PRIORITY) (c) 2001-2006 Red Hat, Inc. [ 1.140000] msgmni has been set to 25 [ 1.190000] io scheduler noop registered [ 1.240000] io scheduler deadline registered (default) [ 1.300000] Serial: 8250/16550 driver, 1 ports, IRQ sharing disabled [ 1.400000] serial8250: ttyS0 at MMIO 0xbc000003 (irq = 37) is a 16550A [ 1.490000] physmap platform flash device: 00800000 at 1e000000 [ 1.560000] physmap-flash.0: Found 1 x16 devices at 0x0 in 8-bit bank. Manufacturer ID 0x0000c2 Chip ID 0x0000a7 [ 1.690000] physmap-flash.0: Found an alias at 0x400000 for the chip at 0x0 [ 1.690000] Amd/Fujitsu Extended Query Table at 0x0040 [ 1.750000] Amd/Fujitsu Extended Query version 1.1. [ 1.810000] physmap-flash.0: Swapping erase regions for top-boot CFI table. [ 1.890000] number of CFI chips: 1 [ 1.940000] Searching for RedBoot partition table in physmap-flash.0 at offset 0x3d0000 [ 2.050000] Searching for RedBoot partition table in physmap-flash.0 at offset 0x3e0000 [ 2.170000] 7 RedBoot partitions found on MTD device physmap-flash.0 [ 2.250000] Creating 7 MTD partitions on "physmap-flash.0": [ 2.310000] 0x000000000000-0x000000030000 : "RedBoot" [ 2.380000] 0x000000030000-0x000000120000 : "kernel" [ 2.450000] 0x000000120000-0x0000003c0000 : "rootfs" [ 2.530000] mtd: partition "rootfs" set to be root filesystem [ 2.590000] mtd: partition "rootfs_data" created automatically, ofs=2C0000, len=100000 [ 2.690000] 0x0000002c0000-0x0000003c0000 : "rootfs_data" [ 2.770000] 0x0000003c0000-0x0000003e0000 : "cfg" [ 2.830000] 0x0000003e0000-0x0000003ef000 : "FIS directory" [ 2.910000] 0x0000003ef000-0x0000003f0000 : "RedBoot config" [ 2.990000] 0x0000003f0000-0x000000400000 : "boardconfig" [ 3.150000] eth0: Atheros AR231x: 00:15:6d:f3:af:0e, irq 4 [ 3.290000] ar231x_eth_mii: probed [ 3.330000] eth0: attached PHY driver [Generic PHY] (mii_bus:phy_addr=0:00) [ 3.420000] Registered led device: wlan [ 3.420000] zram: num_devices not specified. Using default: 1 [ 3.490000] zram: Creating 1 devices ... [ 3.550000] TCP cubic registered [ 3.590000] NET: Registered protocol family 17 [ 3.640000] 8021q: 802.1Q VLAN Support v1.8 [ 3.710000] VFS: Mounted root (squashfs filesystem) readonly on device 31:2. [ 3.800000] Freeing unused kernel memory: 164k freed [ 4.420000] eth0: Configuring MAC for full duplex [ 9.980000] eth0: Configuring MAC for full duplex [ 13.470000] JFFS2 notice: (280) jffs2_build_xattr_subsystem: complete building xattr subsystem, 1 of xdatum (1 unchecked, 0 orphan) and 18 of xref (0 dead, 7 orphan) found. [ 17.990000] Adding 6140k swap on /dev/zram0. Priority:-1 extents:1 across:6140k SS [ 35.730000] Compat-drivers backport release: compat-drivers-2013-01-08-3 [ 35.810000] Backport based on wireless-testing.git master-2013-01-07 [ 35.890000] compat.git: wireless-testing.git [ 36.410000] cfg80211: Calling CRDA to update world regulatory domain [ 36.490000] cfg80211: World regulatory domain updated: [ 36.550000] cfg80211: (start_freq - end_freq @ bandwidth), (max_antenna_gain, max_eirp) [ 36.650000] cfg80211: (2402000 KHz - 2472000 KHz @ 40000 KHz), (300 mBi, 2000 mBm) [ 36.740000] cfg80211: (2457000 KHz - 2482000 KHz @ 20000 KHz), (300 mBi, 2000 mBm) [ 36.840000] cfg80211: (2474000 KHz - 2494000 KHz @ 20000 KHz), (300 mBi, 2000 mBm) [ 36.930000] cfg80211: (5170000 KHz - 5250000 KHz @ 40000 KHz), (300 mBi, 2000 mBm) [ 37.020000] cfg80211: (5735000 KHz - 5835000 KHz @ 40000 KHz), (300 mBi, 2000 mBm) [ 38.870000] ath: EEPROM regdomain: 0x0 [ 38.870000] ath: EEPROM indicates default country code should be used [ 38.870000] ath: doing EEPROM country->regdmn map search [ 38.870000] ath: country maps to regdmn code: 0x3a [ 38.870000] ath: Country alpha2 being used: US [ 38.870000] ath: Regpair used: 0x3a [ 38.880000] ieee80211 phy0: Failed to initialize wep: -2 [ 38.880000] ieee80211 phy0: Selected rate control algorithm 'minstrel_ht' [ 38.890000] ath5k: phy0: Atheros AR2313 chip found (MAC: 0x58, PHY: 0x44) [ 38.970000] ath5k: phy0: RF5112B 5GHz radio found (0x36) [ 39.040000] cfg80211: Calling CRDA for country: US [ 39.150000] cfg80211: Regulatory domain changed to country: US [ 39.220000] cfg80211: (start_freq - end_freq @ bandwidth), (max_antenna_gain, max_eirp) [ 39.310000] cfg80211: (2402000 KHz - 2472000 KHz @ 40000 KHz), (300 mBi, 2700 mBm) [ 39.410000] cfg80211: (5170000 KHz - 5250000 KHz @ 40000 KHz), (300 mBi, 1700 mBm) [ 39.500000] cfg80211: (5250000 KHz - 5330000 KHz @ 40000 KHz), (300 mBi, 2000 mBm) [ 39.590000] cfg80211: (5490000 KHz - 5600000 KHz @ 40000 KHz), (300 mBi, 2000 mBm) [ 39.690000] cfg80211: (5650000 KHz - 5710000 KHz @ 40000 KHz), (300 mBi, 2000 mBm) [ 39.780000] cfg80211: (5735000 KHz - 5835000 KHz @ 40000 KHz), (300 mBi, 3000 mBm) [ 40.480000] ip_tables: (C) 2000-2006 Netfilter Core Team [ 40.940000] nf_conntrack version 0.5.0 (203 buckets, 812 max)